CopperJet 810 ADSL Modem Setup

The following setup is for the CopperJet 810 ADSL modem is best used if the install CD is not available or if the modem has stopped working.

Open your Internet Browser and enter http://172.19.3.1 into the Address bar.  You will be prompted for a username and password. Look in the documentation that was sent with the modem or contact us if you are unable to locate it.

The following screen will appear.

Select PPPoA Routed then click Configure



On the following screen:
Make sure the VPI and VCI are set to 0 & 35
Change the Authentication type to PAP
Enter your UserName  Password
Put a Checkmark in Connect on Demand
Click OK

Save the Configuration to the Modem by Clicking on Save Config under the Configuration Link at the top left.

Then Click System and choose Restart.  After the restart the modem should connect to the DSL service.

If you have any additional questions  please contact us.

CSolutions Tech Support (801) 428-3300 option 3
Qwest DSL Support 1-800-247-7285